Radio-shack Digital Answering System with Big Button Trim Phon User Manual download pdf (Page 13)

Installation

Directly on the Wall

To mount the system on a wall, follow these steps.

Note:

For direct wall mounting, drill two holes 3

inches (82.5 mm) apart, one below the other. Then

thread two screws (not supplied) into each hole, let-

ting the heads extend about

inch (6.3 mm) from

the wall. (Be sure to use screws with heads that fit

into the keyhole slots on the bottom of the system.)

1. Plug one end of the supplied long modular cord

into the modular jack on the bottom of the sys-

tem near its back end.

2. Route the phone cord into

the groove on the bottom

of the system by sliding

the cord under the tabs

along the groove.

3. Plug the other end of the

cord into a modular phone

jack.

4. Fit the heads of the

screws into the keyhole

slots on the bottom of the

system, then slide the sys-

tem down until it is secure.

Phone

Cord

Groove

Tabs

Modular

Jack

Keyhole

Slots

Handset

Jack

Handset

Groove

43-3804.fm Page 13 Thursday, July 6, 2000 2:35 PM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

No comments

Radio-shack Digital Answering System with Big Button Trim Phon User Manual Page 13