© 2004 RadioShack Corporation.All Rights Reserved.RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.ENERGYSTAR and the ENERG
Using Your Phone10Changing the Digital Security CodeThe digital security code is an identification code used to connect the handset and the base unit.
Troubleshooting11TROUBLESHOOTINGIf you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this
43-3556UPZZ01039ZZ01A04Printed in ChinaRadioShack CorporationFort Worth, Texas 76102CAREKeep the phone dry; if it gets wet, wipe it dry immediately. U
Introduction2INTRODUCTIONThank you for purchasing a RadioShack 2.4 GHz Cordless Telephone. Your phone uses the 2.4 GHz band for less interference and
Important Safety Instructions3This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This devic
Installation4INSTALLATIONYou can place the phone on a desk or table, or mount it on a standard wall plate or directly on a wall. Select a location tha
Installation5ON A WALL PLATE OR WALLTo mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slo
Installation6To charge the battery pack, place the handset on the base with the keypad facing forward. The CHARGE/IN USE indicator on the base lights.
Using Your Phone71. Press and hold FLASH until you hear a confirmation tone.2. To set the dial mode for pulse dialing, press #. Or to set the dial mod
Using Your Phone8ADJUSTING THE EARPIECE VOLUMEThe handset earpiece volume settings (Low, Medium and High) can only be adjusted during a call. Press VO
Using Your Phone92. Press MEM. The TALK/BATT LOW flashes. Ô3. Enter the phone number, up to 20 digits. If a pause is needed during the dialing sequenc
Comments to this Manuals