Radio Shack Tone/Vibration Pager Specifications download pdf (Page 20)

Appendix G – Wave Ware Interface Specifications - 20

 System Identification

 Paging Message

 Setup

 Status

PAGING MESSAGE COMMAND

The Paging Message command is formatted as follows:

Example 1:

Example 2:

Note:

The commas, the <CR> character, and the <LF> character are optional in the Paging Message

command. They are used for appearance purposes to separate subparts of the command string and for

formatting the echoed output while troubleshooting the system.

<SOH> (Hex code 01) is used to mark the start of a message. This character resets the paging

system and can be used to abort an incomplete paging command at any point prior to

transmission.

T Alphanumeric character representing the type of paging message to be transmitted

A = Alphanumeric

N = Numeric

1 = One Beep (tone/vibe only pagers)

2 = Two Beeps (all pager types)

3 = Three Beeps (all pager types)

4 = Four Beeps (tone/vibe only pagers)

B Numeric character representing the data rate, in bits per second, at which the paging

message is to be transmitted

5 = 512 bps

1 = 1200 bps

2 = 2400 bps

Note:

This numeric character may have one or no leading commas separating it

from the paging message type.

C...C One to seven decimal numeric digits representing the capcode of the paging receiver

to which the message will be transmitted. Capcodes are seven digit strings. Capcodes

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

No comments

Radio Shack Tone/Vibration Pager Specifications Page 20