Radio-shack 32-2054 User Manual

32-2054Please read this user’s guide before installing, setting up, and using your new amplifier.www.radioshack.comThank you for purchasing your 40-Wat

181917. An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it

©2008. RadioShack Corporation. All rights reserved. RadioShack and RadioShack.comare trademarks used by RadioShack Corporation.09A0832-2054Printed in

23ContentsQuick Start ... 3A Look at Your Amplifier...

45Step 5 Monitor the sound sourceInsert the ¼” (6.35 mm) plug of either mono or stereo headphones (not supplied) to the PHONES jack. Headphones help e

67Rear ViewTerminals (COM, 4, 8,16, 70V)Connect speaker wires to the selected terminals.AC INConnect to a standard AC outlet using the supplied AC

89PreparationPlacing the AmplifierPut your amplifier to a place with adequate ventilation. Do not put it on thick carpeting (which can restrict air flow)

1011ConnectionsConnecting Speaker Wires to the Amplifier1. Use a wire stripper (not supplied) to remove about half inch of the insulation from the end

1213Connecting Four Speakers in Series and Parallel Combination1. Group the four speakers into two pairs (A and B, C and D). Connect each pair of spea

14158, 2.5W Speaker8, 5W Speaker 16, 1.25W SpeakerOutput SideInput SideOutput SideInput SideOutput SideInput SideAAAAAmplifierTransformerTransformer

1617SpecificationsOutput Power (at THD 10%, 4 Load 1kHz).............40WTotal Harmonic Distortion (at 5 Watts, 4