Radio Shack 12-1686 Specifications download pdf (Page 80)

back far enough to scoop the module out with your index finger. Otherwise, it

may be necessary to insert a blunt screwdriver until the tip rests just under-

neath the module. DO NOT pry the module from the console! Slowly increase

the pressure under the module by releasing the tension on the rubber boot. The

module will slide up the screwdriver and exit the console.

WARNING: The following procedure must be closely adhered to.

Damage due to improper battery replacement is not covered by

the DataPlus' limited 2 year warranty.

Examine the case back to find the battery hatch (Fig. 74a), and proceed as

follows to remove the batteries:

• Apply a coin (not a screwdriver) to the recessed slot of the battery hatch,

and turn the hatch out counterclockwise to remove it from the housing. The

battery compartment should only be opened in a dry and clean environment,

with extreme care taken to prevent the entrance of moisture or dust.

• Inspect the o-ring for any signs of deterioration. If found, remove the o-ring

by pressing the sides with your fingertips to cause it to protrude slightly

from the groove of the battery hatch and discard. DO NOT use tools to

remove.

• Closely check the threads of the battery hatch and the housing for any signs

of damage which might impair proper threading. If found, return your

DataPlus to your Authorized Oceanic Dealer, and DO NOT attempt to use

until it has received factory service.

Fig. 74 - Battery Hatch

USE

COIN ONLY

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 105 106

No comments

Radio Shack 12-1686 Specifications Page 80