3
Introduction
• This system is designed for indoor use
only.
• Do not install any camera or monitor
where it will be exposed to high humidity
or rain.
• Select a location for the monitor that will
not be blocked by objects or traffic.
Make sure the selected location is not in
direct sunlight or in line-of-sight with a
direct light source that might make
observing the monitor difficult.
• Do not route any of the connecting
cables close to power or telephone
lines, transformers, or other electrical
equipment that could interfere with your
security system or with any nearby sys-
tems or devices.
• Select a location for the camera and
monitor so the ambient temperature is
between 14° — 113°F (–10° — 45°C).
CONNECTING A CAMERA
The monitor comes with two cables that let
you connect one or two cameras to the mon-
itor. Additional cables for more cameras are
available at your local RadioShack store.
Follow these steps to connect either the Ra-
dioShack Cat. No. 49-2512 or 49-2513 mod-
el cameras.
1. Connect the mini-DIN plug at one end of
the supplied 2-foot cable to one of the
four mini-DIN jacks (
CA1
to
CA4
) on the
rear of the monitor.
2. The other end of the cable has three
jacks and one barrel plug: a white
AUDIO (IN), a yellow VIDEO (IN), a
black AUDIO (OUT) and a DC 12V
(OUT) barrel plug. Connect the yellow
jack, the white jack, and the barrel plug
to the long cable that comes with your
camera as follows:
• Connect the yellow AUDIO (IN) jack
to the yellow AUDIO plug.
• Connect the white VIDEO (IN) jack to
the white VIDEO plug.
• For the Cat. No. 49-2512 camera
only, connect the DC 12V (OUT) bar-
rel plug to the DC12V 200mA barrel
receptacle on the long cable. The
CA
jacks on the monitor, rather than the
external adapter supplied with the
camera, provide the operating power
to the camera.
• For the Cat. No. 49-2513 camera
only, connect the black AUDIO (OUT)
jack to the the camera’s red audio
input plug.
Warnings:
• Do not connect the Cat. No. 49-2513
camera to the DC 12V (OUT) plug.
Doing so can damage the monitor or
camera. Use only the AC adapter
supplied with the camera.
• To use this monitor to power cameras
other than Cat. No. 49-2512, be sure
the selected camera requires 12V DC
at no more than 200mA and has a
matching connector that fits the barrel
plug of the monitor’s provided cable
with the TIP +. If you are not sure, do
not attempt to connect that camera.
Instead, use the power supply pro-
vided with the camera.
3. Connect the mini-DIN plug on the end of
the 79
1
/
2
-foot cable (supplied with Cat.
No. 49-2512) into the mini-DIN jack on
the back of the Cat. No. 49-2512 cam-
era, or the distribution box of Cat. No.
49-2513.
4. Plug the monitor’s AC power cord into a
standard AC outlet.
Camera
Cat. No. 49-2512
49-2511.fm Page 3 Friday, November 17, 2000 4:45 PM
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals