Radio Shack FM Telephone Line Intercom Owner's Manual download pdf (Page 2)

2

2. Drill holes at the marked locations.

3. Thread a screw into each hole allowing

the screw heads to extend about

1

/

8

inch

(3 mm) from the wall.

4. Align the keyhole slots on the bottom of

the station with the screw heads in the

wall. Slide the station down onto the

screws to secure it.

OPERATION

Setting the Channel

Each station has three channels, so you can

select which station or stations you want to

communicate with. You can also use a station

to monitor sounds near another station.

For example, you could set a station installed

in the kitchen to Channel A, a station installed

in the family room to Channel B, and a station

installed in a bedroom to Channel C. Using

the station installed in the kitchen, you can

communicate with the station in the family

room by setting the channel selector to B, or

with the station in the bedroom by setting the

channel selector to C. Or, if you set all sta-

tions to Channel A, you can communicate with

the other two stations from any station.

Set the channel selector on each station as

follows:

• If you want all the stations to communi-

cate with each other at the same time, set

all stations to the same channel.

• If you want to use a station to communi-

cate with only one of the other stations,

set only those stations to the same chan-

nel.

Turning a Station On and Off/

Adjusting the Volume

Rotate

VOLUME

counterclockwise until it

clicks. Then adjust

VOLUME

to a comfortable

listening level. To turn off the station, rotate

VOLUME

clockwise until it clicks.

Calling Another Station

1. Be sure the stations you plan to use are

turned on and adjusted to the desired vol-

ume.

2. Set the channel selector to the channel

(A, B or C) for the station(s) you are call-

ing.

3. Press

CALL

. Each station that is on and

set to the selected channel sounds a

tone.

4. Hold down

TALK

and speak in a normal

voice. When you finish speaking, release

TALK

and listen for the response.

Notes:

• Only one party can talk on a channel at

a time.

• The TALK indicator on the station you

are using remains lit as long as you

hold down

TALK

or

CALL

, or when you

press

LOCK

.

• If your voice sounds distorted, you

might be speaking too loudly or too

close to the microphone.

• Set the channel selector back to your

designated channel after you finish

talking, so others can easily reach you.

Monitoring

You can set any station so it continuously

transmits sounds from the area where it is lo-

cated to another station. For example, you

could set the station in a baby’s bedroom,

then use the station in the kitchen to monitor

the sounds.

Note:

You can monitor only one station at a

time.

1 2 3 4

Comments to this Manuals

No comments