Radio Shack 43-3823 Owner's Manual

© 2003 RadioShack Corporation. All Rights Reserved.RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.E NERGY S TAR and th

Installation 10 3. Plug the battery pack’s connector into the socket in the compartment. The connector fits only one way.4. Put the battery pack in th

Installation11The supplied battery pack should last about a year. If the battery pack does not hold a charge for more than 2 hours after an overnight

Operation121. Press and hold the FLASH until you hear a confirmation tone.2. To set the dial mode for pulse dialing, press #. Or to set the dial mode f

Operation13ADJUSTING THE HANDSET RINGER AND EARPIECE VOLUMEHandset Ringer ToneWhen the phone is in standby mode, press VOL/RING repeatedly to listen t

Operation14TRAVELING OUT-OF-RANGEDuring a call, as you begin to move your handset too far from your base unit, your call will terminate within 1 minut

Memory Dialing15MEMORY DIALINGSTORING PHONE NUMBERS IN MEMORY Memory Dialing allows you to dial a number using just a few key presses. Your phone stor

Memory Dialing16An example of this is a bank account number. Once you have called your bank, and are prompted to enter the account number, press MEM a

The Integrated Answering Device174. To actually store a number, press SPEED DIAL. A tone indicates that the number is stored. If there is a number alr

The Integrated Answering Device18FEATURESDigital Tapeless Recording allows you to quickly review, save, or delete the messages you choose. You will ne

The Integrated Answering Device192. To turn the answering system off, press ANSWER again. After the announcement “Answering system is off” the message

Important Safety Instructions 2 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed

The Integrated Answering Device20Setting the TimeThe clock on the answering system starts when power is supplied to the base. Follow these steps to se

The Integrated Answering Device21Setting a Personal Security Code (PIN)To play your messages from a remote location, you need to enter a two-digit Per

The Integrated Answering Device222. Press SELECT/VOLUME/ or SELECT/VOLUME/ until the desired ring time appears.3. Press set to select the new ring t

The Integrated Answering Device23outgoing message automatically switches to announce only message. To scroll between the prerecorded message or your o

The Integrated Answering Device24automatically deactivate. To reset, go back into the menu setup mode (steps 1 - 3 on page 23).Turning Message Alert t

The Integrated Answering Device25Setting Your Outgoing Message (Greeting)When you receive a call, the answering system automatically plays either a pr

The Integrated Answering Device26Setting the base ringer volumeYou have three ringer options. One allows you to turn the ringer off. The other two are

The Integrated Answering Device27USING YOUR ANSWERING SYSTEMThe message counter displays the number of messages stored in memory. If the display flash

The Integrated Answering Device283. Press at any time to stop reviewing messages and return to standby. The message counter shows the number of mess

The Integrated Answering Device29You can also delete all the messages.1. Press DELETE in standby mode.You hear an announcement “To delete all messages

Important Safety Instructions 3 11. Slots and openings in the telephone’s cabinet and the back or bottom are provided for ventilation. To protect the

The Integrated Answering Device302. To stop recording, press or memo rec. You hear a confirmation tone.Remote access away from homeYou can operate yo

The Integrated Answering Device31*For Memo Record and Greeting Message Record function, the first time you enter the corresponding command, it starts

Additional Information32ADDITIONAL INFORMATIONINSTALLING THE OPTIONAL BELTCLIPTo attach the beltclipInsert the beltclip into the holes on each side of

33TroubleshootingTROUBLESHOOTINGIf your phone is not performing to your expectations, please try these simple steps first .Problem SolutionThe CHARGE/

34TroubleshootingIf you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its i

Care35CAREKeep the phone dry; if it gets wet, wipe it dry immediately. Use and store the phone only in normal temperature environments. Handle the pho

FCC Statement36We have designed your phone to conform to federal regulations, and you can connect it to most telephone lines. However, each phone (and

Notes37NOTES43-3823.FM Page 37 Thursday, March 27, 2003 10:22 AM

Notes38NOTES43-3823.FM Page 38 Thursday, March 27, 2003 10:22 AM

Notes39NOTES43-3823.FM Page 39 Thursday, March 27, 2003 10:22 AM

Battery Safety Instructions 4 • If the product has been exposed to rain or water.• If the product does not operate normally by following the operatin

43-3823UPZZ01012ZZ03A03Printed in ChinaRadioShack CorporationFort Worth, Texas 76102Limited One-Year WarrantyThis product is warranted by RadioShack a

Introduction 5 • Charge the battery pack provided with or identified for use with this product only in accordance with the instructions and limitation

Introduction 6 The digital answering system stores up to 13 minutes of messages on a computer chip and records each message’s day and time. This give

Installation 7 INSTALLATION M OUNTING THE P HONE You can place the phone on a desk or table, mount it on a standard wall plate, or directly on a w

Installation 8 3. Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back.4. Route the adapter’s cord through the strain re

Installation 9 5. For a wall plate , plug the modular cord’s other end into the wall plate jack, then align the base’s keyhole slots with the wall pl