Radio Shack 7-Channel Weatheradio Owner's Manual download pdf (Page 17)

17

Operation

VIEWING THE

TEMPERATURE

DISPLAY

The remote sensor sends

temperature data to the Weatheradio

every 30 seconds. The Weatheradio’s

internal sensor updates the indoor

temperature every 10 seconds.

Note:

If the Weatheradio loses

power, all stored temperatures are

lost.

Press

∧

∧ ∧

∧

or

∨

∨∨

∨

#

to view the maximum or

minimum, indoor and outdoor

temperatures for 10 seconds.

ˆ

Operation

To turn on the Weatheradio, insert the

supplied AC adapter’s barrel plug into

the

DC 9V

jack on the back of

the Weatheradio, then plug the

adapter into a standard AC outlet.

Notes:

• If no signal is received from the

remote sensor for about 2

minutes after power is

connected,

##$#

##$###$#

##$#

appears. Be sure

the sensor’s batteries are

properly installed, the sensor is

within range of the Weatheradio,

and the sensor and the

Weatheradio are set to the same

channel.

• If the clock is not set or a weather

alert has not been received,

##0##ý

##0##ý##0##ý

##0##ý

7C

7C7C

7C

flashes in the center of the

display.

• If a weather alert has been

received, an alert message

appears instead of the time.

To turn the Weatheradio off, unplug

the AC adapter from the AC outlet.

LISTENING TO A

WEATHER

BROADCAST

To listen to a weather broadcast,

press

WEATHER

, then adjust

VOLUME

to the desired listening level. To turn

off the weather broadcast, press

WEATHER

again.

USING THE ALERT

FUNCTION

To set the Weatheradio to sound an

alert when the NWS broadcasts a

warning, watch, or statement, set

ALERT ON/OFF

to

ALERT ON

. A beep

sounds and

7B;HJýED

7B;HJýED7B;HJýED

7B;HJýED

appears.

Notes:

• If you programmed more than

one FIPS code into memory, be

sure the Weatheradio is set to

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments