Radio Shack 3-DVD Changer Owner's Manual Page 21
- Page / 28
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
21
Troubleshooting
ˆ
Troubleshooting
This receiver has been manufactured to the specifications of RadioShack and is covered by a limited warranty from RadioShack. If your receiv-
er is not operating as it should, take it to your local RadioShack store or call 1-800-THE-SHACK for assistance.
Incorrect operation is often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the
points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used.
Symptom Cause Remedy
No power. The power cord is disconnected. Plug the power cord into the wall outlet securely.
The power is on, but the DVD player
does not work.
No disc is inserted. Insert a disc. (Check that the DVD or audio CD indicator in the DVD
display is lit.)
No picture. The TV is not set to receive DVD signal output. Select the appropriate video input mode on the TV so the picture
from the DVD player appears on the TV screen.
The video cable is not connected securely. Connect the video cable into the jacks securely.
The connected TV power is turned off. Turn on the TV.
The playback picture is poor. The disc is dirty. Clean the disc.
The DVD player does not start play-
back.
No disc is inserted. Insert a disc. (Check that the DVD or audio CD indicator in the DVD
display is lit.)
An unplayable disc is inserted. Insert a playable disc. (Check the disc type, color system and
regional code.)
The disc is placed upside down. Place the disc with the playback side down.
The disc is not placed within the guide. Place the disc on the disc tray correctly inside the guide.
The disc is dirty. Clean the disc.
A menu is on the TV screen. Press
SETUP
to turn off the menu screen.
The rating level is set. Cancel the rating function or change the rating level.
The remote control does not work
properly.
The remote control is not pointed at the remote
sensor of the unit.
Point the remote control at the remote sensor of the unit.
The remote control is too far from the unit. Operate the remote control within about 23 ft (7 m).
There is an obstacle in the path of the remote
control and the DVD player.
Remove the obstacle.
The remote’s batteries are exhausted. Replace the batteries with new ones.
The receiver does not respond when
the buttons are pressed.
Static electricity caused by dry air. Disconnect the power plug from the outlet, and insert again.
No sound is output when a function
is selected.
Improper connections Make sure the component is connected correctly.
Sound is muted. Press the remote’s
MUTE
.
The volume is turned down. Adjust
VOLUME
.
No image is output when a function
is selected.
Improper connections. Make sure the component is connected correctly.
The input source is not properly selected. Press the correct function button.
Considerable noise in radio broad-
casts.
Incorrect frequency. Tune in the correct frequency.
The antenna is not connected. Connect the antenna.
Œ
RF (AC-3) and/ or digital cables are near the
antenna terminals and wires.
Route
Œ
RF (AC-3) and digital cables away from the antenna termi-
nals and wires.
(For FM) The FM antennais not fully extended
or is poorly positioned.
Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
(For FM) The signal is weak. Connect an outdoor FM antenna.
(For AM) The AM antenna is poorly positioned. Adjust the direction and position for best reception.
(For AM) The signal is weak. Connect an additional internal or external AM antenna.
Interference caused by other equipment (for
example, flourescent lights, motors).
Turn off the equipment causing the noise or move it away from the
receiver.
Place the antenna farther away from the equipment causing the
noise.
Broadcast stations cannot be
selected automatically.
The signals are weak. Connect an outdoor antenna.
The display is dark or off. The dimmer is on. Press
DIMMER
repeatedly to return to the default setting.
- Theater Audio System 1
- Read this First 2
- MAKING CABLE CONNECTIONS 3
- USING DISCS 3
- IMPORTANT SAFETY INSTRUCTIONS 3
- Note to CATV System Installer 4
- Contents 5
- Features 6
- Preparation 7
- CONNECTING THE SPEAKERS 8
- PLACING THE SPEAKERS 8
- Receiver Operation 9
- USING THE TUNER 10
- USING THE CD PLAYER 10
- USING NIGHT MODE 11
- USING THE SLEEP TIMER 11
- USING THE DIMMER 11
- Remote Control Operation 12
- Changing the Speaker Distance 13
- Changing the Speaker Size 13
- Changing the Channel Level 13
- CONTROL ADDITIONAL COMPONENTS 14
- CONTROLLING THE TUNER 14
- CONTROLLING THE CD PLAYER 15
- CONTROLLING THE SLEEP TIMER 16
- DVD Player Operation 17
- ADVANCED FEATURES 18
- SELECTING TV ASPECT 20
- SELECTING DIGITAL AUDIO OUT 20
- Troubleshooting 21
- Manuracturer’s Codes 23
- VCR Codes 24
- Cable Codes 25
- SAT Codes 26
- Specifications 27
- Speaker Section 28
- Miscellaneous 28
Related products and manuals for CD players Radio Shack 3-DVD Changer
CD players Radio Shack CD-3316 User Manual
(19 pages)
(19 pages)
CD players Radio Shack CD-8400 User's Guide
(20 pages)
(20 pages)
© 2020, manymanuals.com. All rights reserved. | 1.527 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals