10
Preparation
Cautions:
• Do not place the main unit or remote sensor in
direct sunlight, near electrical appliances, or near
heating or air conditioning vents.
• Do not place the main unit in a location where it
is likely to get wet. Only the remote sensor is
weather-resistant.
Main Unit
To set the main unit on a flat surface,
rotate the table
stand on the bottom of the unit clockwise until it
clicks.
To mount the main unit on a wall,
you need a
1
/
8
-inch
(3-mm) screw (not supplied) with a head that fits the
keyhole slot on the back of the main unit.
1. Drill a hole in the wall at the desired mounting
location.
2. Thread a screw into the wall until the head
extends about
1
/
4
inch from the wall.
3. Position the keyhole slot in the back of the main
unit over the screw and slide the thermometer
down to secure it.
Comments to this Manuals