Radio Shack Wireless Indoor/Outdoor Thermometer Owner's Manual download pdf (Page 11)

Preparation

Remote Sensor

To set the remote sensor on a flat surface, insert the

ends of the supplied wire stand into the holes on the

back of the remote sensor above the battery compart-

ment.

To mount the remote sensor on a wall (or on a post

outdoors, for example),

you need two

inch (3-mm)

screws (not supplied) with heads that fit the keyhole

slots on the back of the supplied mounting bracket.

1. Drill two holes 1

inches apart. Then

thread a screw into

each hole, letting the

heads extend about

inch from the mounting

surface.

2. Align the keyhole slots

on the mounting bracket

with the screws and

slide the bracket down-

ward to secure it.

3. Slide the remote sensor into the mounting

bracket.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Radio Shack Wireless Indoor/Outdoor Thermometer Owner's Manual Page 11