Radio Shack 43-141 Owner's Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
31
ERASING MESSAGES
The TAD records new messages over
any old messages you do not want to
save. But, you can erase all stored
messages on a tape at one time. This
is convenient if you want to use tapes
you used in the TAD in other recording
devices, or to prevent others from play-
ing your messages again.
Note:
You must use the controls on
the base to erase messages.
1. Play the incoming messages.
When the TAD has played back
the last message, press and
release
ERASE/STOP
.
2. While pressing and holding down
ERASE/STOP
, press
REWIND
. The
TAD rewinds the tape, then era-
ses all the messages (up to the
end of the new messages). After
the TAD finishes erasing the tape,
it rewinds the tape to the begin-
ning and stops.
Notes:
The TAD will not answer calls
while it is erasing messages. If the
TAD is set to receive calls, press-
ing
ERASE/STOP
sets the TAD not
to answer calls.
To stop erasing messages, press
ERASE/STOP
again.
If you receive a call while erasing,
press
TALK
on the handset or lift
the handset from the cradle to
answer the call. After the call,
repeat Steps 1-2 to continue eras-
ing the messages.
RECORDING A MEMO
You can use the TAD to record a re-
minder for yourself or a message for
someone in your home or office. You
can record a memo using either the
base or the handset.
Note:
When you record a memo, the
TAD saves the memo on the incoming
message tape like other recorded
messages.
Using the Base
Follow these steps to record a memo
at the base.
1. Press
MEMO
. The TAD beeps for
about 2 seconds, and the MEMO
indicator lights.
2. After the TAD stops beeping,
begin recording the message.
Speak in a strong voice from
about 12 inches away from the
front of the TAD.
43-738.fm Page 31 Friday, August 13, 1999 1:51 PM
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Comments to this Manuals

No comments