Radio Shack 43-141 Owner's Manual download pdf (Page 37)

37

Note: If the message tape is full,

the TAD will answer the call and

sound 8 beeps. When the beeps

stop, enter your remote operation

security code within 7 seconds.

2.

While your outgoing message is

playing,

enter your four-digit

remote operation security code.

The TAD sounds a command

prompt.

Note: If you do not enter your

remote operation security code

before the outgoing message fin-

ishes playing, the TAD sounds a

beep, records an incoming mes-

sage, then hangs up.

3. After the TAD sounds the com-

mand prompt, press , then

8

to

set the TAD to answer calls and

record messages. Or, press ,

then

9

to set the TAD to the

announce-only mode.

Note: After the TAD sounds a

command prompt, you can enter

other commands to control the

TAD. See “Using Remote Control

Commands” on Page 38.

To turn off the remote answer on fea-

ture so no one can accidentally access

the TAD, follow these steps using the

TAD’s handset:

1. Press , then

MEMORY

. The

TAD sounds a long beep.

2. Press

1

,

#

, then

MEMORY

. The

TAD sounds a long beep.

To turn the remote answer on feature

back on, repeat this procedure, but

press instead of

#

in Step 2.

Note: You must use the TAD’s hand-

set to turn the remote answer on fea-

ture off or on.

ACCESSING THE TAD BY

REMOTE

To access the TAD by remote, you

must set it to answer calls, or you must

turn it on remotely (see “Remote An-

swer On” on Page 36).

1. Dial your phone number. The TAD

answers your call and you hear

your outgoing announcement.

Note: If you set the toll saver, the

TAD waits four rings before

answering if it has no new mes-

sages. It answers on the second

ring if it has received at least one

new message.

2. When your outgoing announce-

ment finishes and the TAD beeps,

enter your four-digit remote opera-

tion security code. The TAD

sounds a beep and plays back

any new messages. Then the TAD

sounds a command prompt.

3. Hang up the phone, or enter a

remote control command (see

“Using Remote Control Com-

mands” on Page 38.)

43-738.fm Page 37 Friday, August 13, 1999 1:51 PM

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Comments to this Manuals

No comments