Radio Shack PRO-137 User's Guide download pdf (Page 12)

12

(the ﬁrst channel in bank 0), and program the ﬁre

department frequencies starting with Channel 100

(the ﬁrst channel in bank 1).

Transferring Data from Another Scanner or PC

You can clone your scanner by transferring the

programmed data to and from another PRO-137

scanner using a connecting cable. You can also

upload or download programmed data from a PC

through wired programming.

Cloning Your Scanner

You can clone all the frequencies programmed

in one PRO-137 to another PRO-137 using an

optional interface cable with 1/8-inch stereo

phone plugs on both ends (not supplied).

1. Make sure the scanners are turned off and

then plug the cable into each scanner’s PC/IF

jack.

2. Turn on both scanners, then press E

PGM

of the

master unit.

3. Press 1/PRI to stat cloning. Sending data…

appears on the master unit and Receiving data…

on the slave unit.

4. When the data transfer is completed, Finished

appears.

5. After the clone operation is complete, turn

the slave unit off, then remove the cable. Turn

the unit on again.

If you want to clone another scanner, press •CLR

/ L/OUT on the master unit, then repeat the steps

from 2.

Wired Programming

You can transfer programming data to your

scanner using your PC and an optional interface

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments