Radio Shack 63-984 User Manual download pdf (Page 3)

3

2. Place the batteries into the battery

compartment as indicated by the

polarity symbols (+ and –) marked

inside.

3. Be sure the rubber seal around the

battery compartment is properly

positioned, then replace the cover

and tighten the screw.

Replace all four batteries if the transmit-

ter’s indicator lights dimly or not at all

when you press any button on the trans-

mitter.

Warning

: Dispose of old batteries

promptly and properly. Do not burn or

bury them.

Caution:

If you do not plan to use the

door chime for a two week period, re-

move the batteries. Batteries can leak

chemicals that can destroy electronic

parts.

Testing the Chime

Before permanently mounting the

chime, follow these steps to test the sys-

tem

1. With the receiver plugged into a

standard AC outlet, adjust

VOLUME

to its middle position. Then press

BELL

on the transmitter. The chime

should sound.

2. If the chime does not sound, make

certain that the transmitter and re-

ceiver are set to the same channel

and code.

3. Adjust

VOLUME

on

the receiver to

the desired listening level.

Mounting the Transmitter

Mount the transmitter within 50 feet of

the receiver using the supplied mounting

hardware. Depending upon the mount-

ing surface material of your home (wood

siding, brick face, and so on), you might

need to c

onsult your local hardware

store for a different type of mounting

hardware.

Note

: While the transmitter is water-

resistant, it is not waterproof. If you

are mounting the transmitter out-

doors, select a location that provides

some shielding from the elements.

Follow these steps to mount the trans-

mitter.

1. Drill four

3

/

16

-inch diameter holes into

the mounting surface (as shown be-

BELL

63-984.fm Page 3 Wednesday, September 8, 1999 4:42 PM

1 2 3 4 5 6

Comments to this Manuals

No comments