Radio Shack 20-163 User's Guide download pdf (Page 34)

For Motorola Type II, enter 15.

6. Press ENT. The next block appears.

7. Repeat steps 5-6 for each block. If you make a mistake, press CL

and enter the correct size code.

Base and Offset Frequencies

To receive Motorola VHF and UHF system transmissions, you must

program applicable base and offset frequencies. In the 800 MHz

trunking band, you can select a base frequency (normal or offset),

but in the 900 MHz trunking band, you do not need to set the base

frequency.

You can get information about base and offset frequencies from

www.trunkscanner.com.

UHF-Lo (406-512 MHz)

To program Motorola base and offset frequencies:

1. Press PROG then TRUNK to enter the ID program mode.

2. Press FUNC, then press  or . The bank number increases or

decreases by one. If you hold down  or , the bank number

increases or decreases continuously.

3. If necessary, repeatedly press MODE to select “Motorola.”

4. Press FUNC then 2. The screen displays the Base, Offset, and

Step with the B in Base blinking.

5. If necessary, use the number keys to enter a new Base frequency

and press ENT. The O in Offset blinks.

6. If necessary, use the number keys to enter a new Offset frequency

and press ENT. The S in Step blinks.

If you try to program an offset frequency in the UHF-Hi bands

(806-960 MHz), the scanner ignores the entry.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 65 66

No comments

Radio Shack 20-163 User's Guide Page 34